Our 3D printed Skull Dice Tower is just the gaming accessory you need for, well, all your adventure games. Pirates, graveyards, watery cemeteries, and even desert islands, who doesn’t need a skull on their gaming table? Torment your players by making them roll all their death saves in the skull in the center of the table. Why not?!

You have three skulls to choose from - small (for mini pocket dice only), medium (for dice 16mm and smaller), and large (for dice 30mm and smaller). Drop your dice in either eye socket because momma always said not to put things in your nose. The dice travels down a chute and comes out into the mouth tray.

Our skulls are also perfect as decorations, display trays, and are even light enough to hang on your wall with a command strip. Make sure to pick up more than one though because they don’t like to be alone.

Note: We print these with PLA filament. They can be aged/patinaed to create a more weathered look but will require effort to do so. Please use caution when using any chemical as it may cause a negative reaction and +3 to Charisma does not guarantee any specific outcome if these are modified. Check out our Instagram for dice rolling videos.

Measurements:

Small - We call him Mel. This little one and measures about 5 inches/12.7cm long, 3.5 inches/8.89cm wide, and 4.5 inches/11.43cm from the base to teeth tips.

Medium - This is Jeff. Jeff measures 7 inches/17.78 cm long, 5 inches/12.7cm wide, and about 6 inches/15.25cm from bottom to teeth tops.

Large - This big boi we call The Colonel! It measures almost 8 inches/20.3 cm long, 6 inches/15.25 cm wide, and is almost 7 inches/ 17.78 cm from the base to the top of the open mouth.